CV boot pictures by jimmypsp700

102_2662.jpg inner CV retainer clip, pry appart to remove shaft from Cv joint. image by jimmypsp700

102_2663.jpg CV joint and clip image by jimmypsp700

102_2664.jpg inner spline and CV, top veiw image by jimmypsp700

102_2668.jpg shaft removed, inspect bearings. image by jimmypsp700

102_2670.jpg C-clip , use anti-seize on inner spline to diff. image by jimmypsp700

102_2671.jpg be sure to seat clip in sline ring groove upon install image by jimmypsp700

102_2672.jpg rear replacement boot image by jimmypsp700

102_2673.jpg OEM on Right image by jimmypsp700

102_2674.jpg NAPA rear Boot P/N image by jimmypsp700

102_2675.jpg new boot , fill boot and joint w/grease, clamp last image by jimmypsp700

102_2676.jpg Cv shaft installed, use anti-seize on shaft slines. image by jimmypsp700

102_2678.jpg replace hub &amp;amp; rotor. image by jimmypsp700

102_2679.jpg torq castle nut to 80 ft lbs, replace cotter pin and rubber cap. image by jimmypsp700